Features Of Patented Hydraulic High
Full Stroke in 8 seconds!
(U.S. Patent 4,482,330)
Made of 3/4 and 1/2 inch 6061 T6 alloy aluminum extrusions and fastened with
stainless steel fasteners. Ideal for fresh or salt water use. No welds
or castings to break.
The dependable self contained and water proof high speed hydraulic actuator
has a max. lifting capacity of 4417 pounds of thrust. You will have no problem
lifting even a V-6 300 hp max. motor at full throttle. The hydraulic actuator
is mounted inside the structure of the Power-Lift, yet it is fully accessible
without removing the engine. There are no hoses to contain, nor will
you have to contend with mounting a pump and reservoir inside your boat, as is
the need with other transom jacks. The hydraulic actuator is
completely self-contained with its own fluid reservoir (eliminates the need
for hydraulic tank and hoses inside the boat). It contains a permanent magnet
motor for more power and constant torque. The cylinder within the actuator has
more lifting capacity than other transom jacks on the market. It contains a
no-leak seal and wiper that keeps dirt and water out of the working parts. The
system is made of 100% non-ferrous material which makes it impervious to
saltwater and freshwater.
The patented roller design means less friction, longer wear, less maintenance,
and virtually no binding problems which are common with other transom jacks.
The roller assembly contains a stainless steel 3/4" pin with aluminum-bronze
alloy rollers. The roller is highly impact resistant, corrosive resistant, and
has a high load carrying capacity. This patented design virtually
eliminates any chance of binding which is common with other transom jacks.
The PL-65 HS is rated for V-6 motors and
smaller and gives you 5" of vertical travel with 1-1/2" of adjustment on the
motor bracket and 1-1/2" of adjustment on the transom bracket. A TOTAL OF
8" OF POSSIBLE ADJUSTMENT! It also can be purchased with stainless steel
motor rails, Model PL-65SS (for V-8 motors 300 HP MAX).