QT 130 HP
The QT LED 130 High Powered is a flush ”through-hull” submersible
marine light suitable for GRP-Fibreglass and wooden hulls. We advise that the
light be installed 250mm below the waterline. Maintenance of the light is
carried out from inside the hull, dry docking is not necessary. The LED is
easily removed and replaced from the projector barrel.
The QT LED 130 HP comes fully assembled and ready for installation when the
securing and compensating rings are removed. The underwater light is supplied
fully assembled with 3 meters of cable connected to a IP68 plug which plugs
directly into the driver enclosure socket. The aluminium driver enclosure has a
IP68 socket fitted tted for plug and play. This connection is suitable for
single driver only. For installation into a cabinet with a maximum of eight
drivers in series, wiring from lights to drivers is required.
The LED has a wide beam of around 87 degree . The high powered LED (18,500
lm) is available in cool white 6,500K and Royal Blue
||144 LEDs -separated in 4 channels.
||Armor coated Aluminium bronze & 5083 alu
||Growth Resistant Borosilicate Glass
|Voltage & Amps
||Supply 110 to 240vac-Max power 130w.
||4 channel 36vdc/1.4amps per channel
||40,000 hours @ 35° C.
Installation & Instructions
The hole cut-out should be 101mm. Hull thickness range 12mm to maximum 120mm.
For LED maintenance allow 170mm behind the cover.
Driver must be fitted minimum 0.60m above tank space with good ventilation
and the maximum ambient temperature should not exceed 40C.
All drivers single or in cabinets are connected in series. The DMX control is
connected at one end and the driver at the end of the series has to be
For single driver connection- 3m of 10 core cable ( Part number QTE-G52322)
is supplied for lights to drivers connection. For cabinets connection- 10 core
cable is required and not supplied for lights to drivers- ( Part number
QTE-G52322) The DMX cable is not supplied but is available on request- ( Part
number QTE-G13500- 2 core).