Minn Kota Edge

Refers to how powerful the motor is. Boat weight is key when determining how much thrust you need. General rule of thumb: you need at least 2 lbs. of thrust for every 100 lbs. of fully-loaded boat weight (people and gear included). If things like wind or current are major factors where you fish, you�ll want a little extra thrust.

Indicates how much battery power your trolling motor requires. You�ll need 1 battery for every 12 volts in your trolling system. 55 lbs. of thrust or less = 12 volts, 1 battery 68-80 lbs. of thrust = 24 volts, 2 batteries 101-112 lbs. of thrust = 36 volts, 3 batteries

How do I select trolling motor shaft length?

Choosing the correct shaft length is important so that the angler's electric motor does not cavitate, creating fish-spooking noise. The rule of thumb is that the top of the motor section should be submerged 12". In general, shaft length selection is more critical with bow-mount motors versus transom-mount motors. Most boat transoms are similar in their distance to the water, and Minn Kota�s standard transom shaft lengths should be adequate. With bow-mounted motors, there is much greater variation in shaft length requirements. Measure down from the mounting surface of the transom or bow to the water level. Add 5" to waterline measurement for fishing in rough water. Add 12" to waterline measurement for steering a hand control motor while standing. Use this measurement and the tables below to find the appropriate shaft length.

Transom Guide

TRANSOM TO WATERLINE	RECOMMENDED SHAFT LENGTH
0" - 10"	30"
10" - 16"	36"
16" - 20"	42"
Over 22"	Consult Factory

Bow Guide

BOW TO WATERLINE	RECOMMENDED SHAFT LENGTH
0" - 10"	36"
16" - 22"	42" - 45"
22" - 28"	48" - 52"
28" - 34"	54" - 62"
34" - 44"	72"

Engine Mount Guide

Minimum clearance required from spine of outoard to end of cavitation plate (see diagram below).
Cavitation plate to waterline 13" (minimum).

WHAT TECHNOLOGIES MATTER TO YOU?

Uses GPS to lock onto fishing spots, record and retrace paths, command speed and steering, and more�all from a wireless remote with an LCD screen.

Gives you all the features of i-Pilot, plus the ability to connect your Minn Kota trolling motor to your Humminbird fish finder for a fully-integrated fishing experience.

Get streamlined, interference-free sonar performance as the transducer and wiring run through the motor shaft to stay completely concealed and protected.

Allows you to stay on any heading you choose and your boat stays on course while your motor automatically corrects for wind, waves and current.

Motors with Digital Maximizer draw only as much power as you need, so they don�t waste any energy.

With a Built-In MEGA Imaging transducer get the best images of what�s below delivered right to your Humminbird fish finder�with no cluttered wires, no clamps, and a transducer that�s fully protected.