|  
 
 Maretron Current Transducer with Cable for DCM100, 400A, LEMHTA400-S
 
 
	Maretron's DCM100 DC Monitor is an advanced electronic monitoring device used 
to measure the voltage and current of any direct current (DC) power source or 
load. Examples of DC power sources that can be monitored with the DCM100 include 
batteries, alternators, solar panels, and wind generators. The DCM100 can also 
be used to monitor DC loads like inverters, windlasses, DC refrigerators, or any 
DC branch circuit. When the DCM100 is used to monitor batteries, sophisticated 
circuitry and software algorithms monitor battery temperature, load current, 
charging current and terminal voltage to precisely compute battery state of 
charge, and time remaining. To measure current, the DCM100 uses an included 
state-of-the-art Hall effect current sensor which simply slips over the wire - 
you don't have to break connections or install connectors as you do with inline 
shunts used by other solutions. Best of all, the DCM100 is NMEA 2000
	® 
certified so you can view any and all DC information anywhere on the vessel 
using a compatible NMEA 2000
	® display.
 
	The DCM100 is a key component of Maretron's N2KView® 
vessel monitoring and control system.
 
	Battery voltageBattery currentRipple voltageBattery case temperatureState of chargeTime remainingCharge efficiency factor 
	
	
	Pin Number (Signal Name Connection)
		1 (IA Current Sensor, Red Wire)2 (IB Current Sensor, Green Wire)3 (IC Current Sensor, Black Wire)4 (ID Current Sensor, White Wire)5 (V SENS+ Battery, + Terminal)6 (V SENS- Battery, - Terminal)7 (V PWR- Vessel Ground)8 (V PWR+ 9-32 VDC Power)9 (N/A No Connect)10 (N/A No Connect)11 (TA Temperature Sender, Red Wire)12 (TB Temperature Sender, Black Wire) 
 |