Can I switch my RCL-100D light unit with the new LED Version?
Yes, but you will also need to replace your existing master controller with
a new URC-103, which is included in P/N 1951.
Why do I need a new Master Controller if I am just switching to the LED
version of the RCL-100?
The URC-102 Master Controller (RCL-100D) has a slow turn on voltage for the
halogen bulbs which the LEDs do not need. The voltage for the halogen bulbs,
after switch on, is continuously regulated, which induces noise in the LED
Is there any wiring difference between the ‘old’ and new RCL 100/LED?
The same coax cable, point pad and wire harness colors are used.
Is the RCL-100 LED light compatible with 12V or 24V systems?
It is compatible with both 12 and 24 V.
How long will the LED lights last on the RCL-100 LED?
The LED’s are rated to last over 40,000 hours each.
If one LED bulb fails, can it be repaired?
The complete LED Power Head Assembly must be replaced.
Can the URC 103 controller for the LED version be used on the RCL 100D
This controller will blow the halogen bulbs at switch on.
What is the maximum current (Amp) that the light need to be supplied with?
The light uses a maximum of 3.5 Amp and has a 5 amp fuse installed.