Seastar BA200-11TMC Hydraulic Cylinder 29.7 cubic inches, HC5379

INTRODUCTION
Capilano Helms and Cylinders are engineered and manufactured for heavy duty marine usage, and are suitable for commercial, work boat and pleasure boat applications. Capilano Hydraulic Steering has been designed to meet ABS, Lloyds and DNV specifications.

For all Pleasure and Work Boat applications 38ft. (11.5m) and smaller with some exceptions, please refer to our SeaStar range of Inboard Steering Systems.

Features
• Regular duty aluminum cylinders.
• Heavy duty cylinders.
• Easy installation for single and dual rudder vessels.
• Cylinders supplied with bleeder fittings.
• Two axis articulation.
• Easy autopilot interface.

GUIDE

a) Consult Manufacturer for hull lengths.

back to top……………………………………………………………………………………………………………………………….

CYLINDER INSTALLATION
Proper cylinder installation is the key to the successful operation of the hydraulic steering system. An incorrectly installed cylinder is subject to rapid seal and bearing wear and non-repairable damage.

An imaginary line drawn through the tiller arm hole at both hard over positions will create the cylinder centre line. With tiller arm at hard over positions, angle X and Y should be the same. Select the diagram and dimensional data that corresponds with your cylinder model.

Notice
Not all possible cylinder mounting configurations are shown, however, all necessary dimensions are shown regardless of mounting configurations.

back to top……………………………………………………………………………………………………………………………….

CAPILANO HELM PUMPS
1250V, 1275V & 1350

A unique variable displacement feature on the 1250V and 1275V helms allows the helms-person to adjust the amount of steering wheel turns to their preference within a predetermined range. The 1350 helm is a fixed displacement pump.

1250V & 1275V Helm Pumps

1350 Helm Pump

back to top……………………………………………………………………………………………………………………………….

TUBING, HOSES and FITTING KITS
The use of seamless soft annealed refrigeration copper tubing, type L is recommended. If flexible hose is required, use hose that has a minimum operating pressure of 1000PSI, a burst pressure of 5000PSI and the lowest available expansion factor. The 1250V requires the use of 1/2″ OD copper tube while the 1275V requires the use of 5/8″ OD copper tube. The 1350 Helm Pump requires the use of 3/4″ OD copper tube.

Cylinder Hoses
Steering systems installed with copper tubing require short pieces of flexible hose to accommodate slight cylinder movement. Hoses are supplied with 1/2″ swivel flare nuts on each end. Hoses are sold as a pair for single cylinder applications and separately for the variables of twin cylinder installations.

Fitting Kits

Single steering station and additional steering station S.A.E. flare tube fitting kits are available for use with 1/2″ O.D. and 5/8″ O.D. copper tubing.

Fill and Vent Plug Kit
This kit will facilitate filling and purging of the steering system at a more convenient and accessible area than the helm pump. A through dash fitting, complete with a waterproof vent plug, 18″ (0.45m) long vinyl tube and elbow fittings are supplied with this kit

back to top……………………………………………………………………………………………………………………………….

TECHNICAL INFORMATION

**The price is subject to change at anytime without any notice.  We are not responsible for any typographical errors.  Any products can be cancelled from sale at any time.

** All Products sold here are Brand New unless specified Otherwise and come with Full Manufacturer's Warranty

WARNING: This product can expose you to chemicals including Di-n-hexyl Phthalate (DnHP) which is known to the State of California to cause reproductive harm, and Vinyl Chloride which is known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov. __________________________________________________________________________________________

__________________________________________________________________________________________